Fitting
and use of restraining systems on fork lift trucks
Applies
from December 2002
In general terms, seat belts will not be required where:
- The truck has a high degree of stability making it unlikely that it could overturn when used in its normal operating environment for which it was designed. This would normally apply to all trucks with a capacity greater than 10 tons
- The truck is a masted truck that can only roll through 90 degrees and features on the truck prevent the operator being trapped between the truck and the ground. This would normally infer an enclosed cab with doors that cannot be held open or removed during routine operations
- The operator sits sideways and gains access from the rear only. This applies to the majority of reach trucks
- The truck has a stand - on operator
Trucks of greatest concern are those which may overturn and trap the operator
between the truck and the ground or allow him/her to be thrown around
in the cab as the truck overturns beyond 90 degrees.
Summary of requirements
Since 5th December 2002, equipment that comes under the auspices of these
regulations should be fitted with operator restraints which would normally
indicate the use of some sort of seat belt arrangement.
It is acknowledged that some older trucks cannot have restraints fitted and some, such as those with unsecured batteries, would become more dangerous if they were. This problem has been overcome by making the actual use of the equipment the determining factor. This means that a risk assessment is required for each task that the truck is likely to perform. In each case an assessment must be made about the potential for overturn and if there is a chance of it then a truck fitted with restraints must be used. If there is a negligible chance that the truck could overturn then a truck without restraints may be used.
Since the safety of lift truck operators is the responsibility of the employer it follows that the employer must be responsible for the risk assessment and must be capable of identifying a low risk of truck overturn.
The regulations also have the effect that newly hired trucks be treated as new. This means that trucks coming under a new hire arrangement should be fitted with restraints. Where this is impracticable then again a risk assessment is required by the employer to justify a low risk of overturn when the truck is in use. It would be a good idea in these circumstances if the risk assessment were to be conducted jointly by the supplier and the employer and in reality many companies will do this. It should remain clear however that the final responsibility for the risk assessment rests solely with the employer.
© AES Training Services
Site updated
30th August 2007
